10-18-2009, 01:51 PM
Received this question from a reader of the blog:
I was Trying to time a VW bus motor Im not sure what size I was told it was an 1800 it’s on a sandrail. The distributor poped out. how do I align the distributor with the cam. It is in two pieces the middle conection can only go one way but the other end has 13 teeth. Any ideas?
I was Trying to time a VW bus motor Im not sure what size I was told it was an 1800 it’s on a sandrail. The distributor poped out. how do I align the distributor with the cam. It is in two pieces the middle conection can only go one way but the other end has 13 teeth. Any ideas?